j'obtiens une erreur quand je veux installer libHermes:
>>> Install hermes-1.3.2-r2 into /var/tmp/portage/hermes-1.3.2-r2/image/=20
category media-libs
make: *** No rule to make target `install'. Stop.
!!! ERROR: media-libs/hermes-1.3.2-r2 failed.
!!! Function src_install, Line 49, Exitcode 2
!!! (no error message)
=E7a ressemble =E0 un probl=E8me d'automake, car si je vais=20
dans /var/tmp/portage/hermes-1.3.2-r2/work et que je fais "=E0 la main" les=
=20
=E9tapes de l'ebuild, quand je tape "automake -a" j'obtient:
src/Makefile.am: Assembler source seen but `CCAS' is undefined
src/Makefile.am:
src/Makefile.am: The usual way to define `CCAS' is to add `AM_PROG_AS'
src/Makefile.am: to `configure.in' and run `aclocal' and `autoconf' again.
src/Makefile.am: Assembler source seen but `CCASFLAGS' is undefined
src/Makefile.am:
src/Makefile.am: The usual way to define `CCASFLAGS' is to add `AM_PROG_AS'
src/Makefile.am: to `configure.in' and run `aclocal' and `autoconf' again.
je patauge compl=E8tement avec les autotools. quelqu'un a-t-il d=E9j=E0 eu =
ce=20
probl=E8me?
pas facile d'obtenir des infos sur la libHermes...elle semble maintenant fa=
ire=20
partie de clanLib, mais quand je compile cette derni=E8re, point de=20
libHermes.so.1...
